Beyond FlipScreen Installationsanleitung PDF herunterladen (Seite 17)

RPSB 1800/1802 Installation Guide

Appendix C: Integrating a Video Camera and

Shelf

To integrate a video camera and shelf, you must first gain access to the cabinet interior by

removing the Rear Access Panel and Lower Baffle Door as described on page 8 of this guide.

You do

not

need to remove the SMART Board screen.

NOTE

: The camera shelf may be mounted on either side of the cabinet. We recommend that

you mount it opposite the optional Flip-Up Shelf.

To integrate a video camera and shelf:

1. From inside the cabinet, push out the Hole Cover found on the top side of the cabinet

near the screen. From the outside, remove the three Shelf Mounting Screws around the

Hole Cover using the 1/8” Allen key provided. Keep these screws for use in Step 2.

2. Place the Camera Shelf over the large hole and fasten it to the cabinet with the three

Shelf Mounting Screws removed in Step 1.

3. If your camera has a standard 1/4-20 camera mount, use the 1/4-20 Screw provided to

mount the camera through one of the series of holes on top of the Camera Shelf. Use the

3/16” ball driver which came with the cabinet. Depending on the height of the camera’s

feet, you may need to use some of the Washers provided to adjust the height of the

screw.

4. Connect the camera cables to the camera. Route the cables beneath the shelf and

through the large hole in the side of the cabinet.

5. From inside the cabinet, find the optimal route to keep the wires snug to the inside of the

cabinet. Use the Adhesive Cable Ties provided. If necessary use the extension cables

provided to connect to your computer.

6. Install the Camera Shelf Light Baffle with the two screws provided. Use the 1/8” Allen

key provided.

Adhesive

Cable Ties

Hole Cover

Shelf Mounting

Screws and

Camera Shelf

1/4-20

Mounting Screw

and Washers

Camera Shelf

Light Baffle

Camera Cables

Cut-Away View of Cabinet

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Beyond FlipScreen Installationsanleitung Seite 17