Beyond INF-B Betreibershandbuch PDF herunterladen (Seite 54)

Input Type Selection

12 INPUT TYPE SELECTION: (INPUt)

12.1 INPUT TYPE: (THERMOCOUPLE)

INPUt ENTER INPUT TYPE MENU:

Press ‘MENU’ 1) Display shows "INPUt" Input Menu.

Press ‘RESET/ENTER’ 2)

Display flashes "VOLt" or previous stored input type.

Press ‘䊱/MAX’ 3) Scroll through the available following input type selection list. Display

flashes:

"VOLt" (DC Voltage)

"CURRNt" (DC Current)

"bRIdGE" (Bridge)

"POt" (Potentiometer)

"tC" (Thermocouple)

"Rtd" (RTD).

If the displayed input type is "tC", press ‘RESET/ENTER’ to skip to Step 6

("tC" stops flashing).

t.C "t.C" THERMOCOUPLE SUBMENU:

Press ‘䊱/MAX’ 4) Scroll through the available selection to "tC" (flashing).

Press ‘RESET/ENTER’ 5) Display shows "tC" again, but not flashing.

Press ‘RESET/ENTER’ 6) Display flashes previous thermocouple type selection. ie. "J tC" as

default, (see Table below for types). If the display matches your choice of

Thermocouple. Go to Step 8.

Press ‘䊱/MAX’ 7) Scroll through the available thermocouple types to the selection of your

choice.

Press ‘RESET/ENTER’ 8) Display shows "StOREd" stored message momentarily and then

advances to the "RdG.CNF" Reading Configuration Menu.

Thermocouple

Types: J

K T E N DIN J R S B

Display: J tC k tC t tC E tC N tC dNJ tC R tC S tC b tC

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 131 132

Keine Kommentare

Beyond INF-B Betreibershandbuch Seite 54